Coming Home Light - Mitsubishi Lancer Owner's Manual
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Instruments and controls
NOTE
l
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
3
• Turn the combination headlamps and dip-
per switch to the "
" or "
• Turn the ignition switch to the "ON" po-
sition.
l
It is possible to modify functions as follows:
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
• Except for vehicles for Russia, Kazakh-
stan and Ukraine, deactivating the wel-
come light function.
• Vehicles for Russia, Kazakhstan and Uk-
raine, activating the welcome light func-
tion.
• The headlamps can be set to come on in
the low beam setting.
3-46
Coming home light
This function turns on the headlamps in the low
beam setting for about 30 seconds after the ignition
switch is turned to the "LOCK" position.
1. Turn the combination headlamps and dipper
switch to the "OFF" or "AUTO" position
(for vehicles equipped with the automatic
lamp control).
2. Turn the ignition switch to the "LOCK" posi-
tion. Also, if a key was used to start the en-
gine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition
switch to the "LOCK" position, pull the turn
signal lever towards you.
" position.
OG1E12E1
4. The headlamps will come on in the low
beam setting for about 30 seconds. After the
E00529000249
headlamps go off, the headlamps can be
turned on again in the low beam setting for
about 30 seconds by pulling the turn signal
lever towards you within 60 seconds of turn-
ing the ignition switch to the "LOCK" posi-
tion. To turn on the headlamps again after 60
seconds of turning the ignition switch to the
"LOCK" position, repeat the process from
step 1.
NOTE
l
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the lever towards you.
• Turn the combination headlamps and dip-
per switch to the "
• Turn the ignition switch to the "ON" po-
sition.
l
It is possible to modify functions as follows:
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
• The time that the headlamps remain on
can be changed.
• The coming home light function can be
deactivated.
" or "
" position.
Hide quick links:
Advertisement
Chapters
Table of Contents
