Reversing Sensor System - Mitsubishi Lancer Owner's Manual
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Starting and driving
WARNING
l
On vehicles with CVT or Twin Clutch
SST, although the set speed driving will
be deactivated when shifting to the "N"
(NEUTRAL) position, never move the se-
lector lever (CVT) or the gearshift lever
(Twin Clutch SST) to the "N" (NEU-
TRAL) position while driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactivated as
follows:
l
When the engine speed rises and approaches
the tachometer's red zone (the red-coloured
part of the tachometer dial).
4
CAUTION
l
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the "ON-OFF" switch to turn off
the cruise control and have your vehicle
inspected by a MITSUBISHI MOTORS
Authorized Service Point.
4-66
To resume the set speed
E00609800503
If the set speed driving is deactivated by the condi-
tion described in "To deactivate" on page 4-65,
you can resume the previously set speed by press-
ing the "ACC RES" switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
Type 1
Type 2
Under either of the following conditions, however,
using the switch does not allow you to resume the
previously set speed.
In these situations, repeat the speed setting proce-
dure:
l
The "ON OFF" switch is pressed.
l
The ignition switch is turned OFF.
l
"CRUISE" indication lamp is turned OFF.
OG1E12E1
Reversing sensor system*
E00615500358
This system operates when you are backing the ve-
hicle. It uses corner and back sensors to detect an
obstacle and the information screen in the multi-in-
formation display and the buzzer to inform you of
the approximate distance to the obstacle.
CAUTION
l
The reversing sensor system assists you in
determining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in
terms of detectable areas and objects,
and may not properly detect some ob-
jects. Therefore, do not place excessive
confidence in the reversing sensor system
and operate the vehicle as carefully as
you would do with a vehicle not equipped
with this system.
l
Make sure to check the surroundings
with your own eyes to ensure safety. Do
not operate the vehicle by relying on the
reversing sensor system alone.
Obstacle detection areas
E00615600160
The detection areas of the corner and back sensors
are limited to those shown in the illustration. More-
over, the sensors are unable to detect low or thin ob-
jects or objects near the rear bumper. Thus, make
sure to check the surroundings as you operate the
vehicle in a safe manner.
Hide quick links:
Advertisement
Chapters
Table of Contents
