Mitsubishi Lancer Owner's Manual page 340
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
CAUTION
l
If you shake the bottle after screwing on
the hose, sealant may spray out of the hose.
8. Take the valve cap (F) off the tyre valve (G),
then press the valve remover (H) onto the
valve as illustrated. Allow all of the air in the
tyre to escape.
9. Remove the valve insert (I) by turning it anti-
clockwise using the valve remover (H). Put
the removed valve insert in a clean place so
it does not get dirty.
CAUTION
l
If there is any air left in the tyre when
you remove the valve insert, the valve in-
sert may fly out and injure you. Make
sure the tyre contains no air before remov-
ing the valve insert.
10. Remove the plug (J) from the free end of the
hose (K). Press the hose onto the valve (G).
OG1E12E1
For emergencies
11. Holding the sealant bottle upside-down,
squeeze it again and again to inject all of the
sealant into the tyre.
NOTE
l
When injecting the sealant, position the
valve away from the bottom, i.e., away from
the point where the tyre touches the ground.
If the valve is near the point where the tyre
touches the ground, the sealant may not go in-
to the tyre easily.
12. After injecting the sealant, pull the hose off
the valve, remove any residual sealant from
the valve, rim and/or tyre.
6
6-09
Hide quick links:
Advertisement
Chapters
Table of Contents
