Mitsubishi Lancer Owner's Manual page 346
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
To change a tyre
E00803200448
1. On vehicles with wheel covers, first remove
the covers (refer to "Wheel covers" on page
6-18). Then loosen the wheel nuts a quarter
turn with the wheel nut wrench. Do not re-
move the wheel nuts yet.
2. Place the jack under one of the jacking
points (A) shown in the illustration. Use the
jacking point closest to the tyre you wish to
change.
WARNING
l
Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
l
Do not use the jack on a tilted or soft sur-
face.
Otherwise, the jack might slip and cause
personal injury. Always use the jack on a
flat, hard surface. Before setting the jack,
make sure there are no sand or pebbles
under the jack base.
OG1E12E1
For emergencies
3. Rotate the jack by hand until the flange por-
tion (B) fits in the groove (C) at the top of
the jack.
4. Insert the bar (D) into the wheel nut wrench
(E). Then put the end of the bar into the
shaft's jack end, as shown in the illustration.
6-15
6
Hide quick links:
Advertisement
Chapters
Table of Contents
