Mitsubishi Lancer Owner's Manual page 395
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Maintenance
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Headlamps (high/low beam, for vehi-
cles with high intensity discharge head-
lamps)
8
Do not attempt to disassemble or repair headlamps,
and do not attempt to replace their bulbs.
8-30
WARNING
l
A high voltage is present in the power cir-
cuit and in the bulbs and bulb terminals.
To avoid the risk of an electric shock, con-
tact a MITSUBISHI MOTORS Author-
ized Service Point whenever repair or re-
placement is necessary.
Bending lamps (Adaptive Front light-
ing System (AFS)) (for vehicles with
high intensity discharge headlamps)
1. When replacing the bulb on the right side of
the vehicle, remove the bolt (A) holding
down the washer tank spout and move the
spout towards the rear of the vehicle.
*: Front of the vehicle
E01010100031
OG1E12E1
2. Turn the cap (B) anticlockwise to remove it.
E01008800204
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
*: Front of the vehicle
Hide quick links:
Advertisement
Chapters
Table of Contents
