Mitsubishi Lancer Owner's Manual page 399

Table of Contents

When unfastening the screws, be careful not

to mistakenly move the beam position adjust-

ment screw (C).

3. Push the connector (D) to disconnect and re-

move the fog lamp.

4. Remove the bulb assembly (E) by turning it

anticlockwise.

Handle halogen lamp bulbs with care.

The gas inside halogen lamp bulbs is high-

ly pressurized, so dropping, knocking, or

scratching a halogen lamp bulb can cause

it to shatter.

Never hold the halogen lamp bulb with a

bare hand, dirty glove, etc.

The oil from your hand could cause the

bulb to break the next time the fog lamps

are operated.

If the glass surface is dirty, it must be

cleaned with alcohol, paint thinner, etc.,

and refit it after drying it thoroughly.

5. To install the bulb, perform the removal

steps in reverse.

Show Quick Links

Chapters

Table of Contents