Mitsubishi Lancer Owner's Manual page 47
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Locking and unlocking
• The time for automatic relocking can be
changed.
• Activating the operation confirmation
function (blinking of the turn-signal
lamps) only during locking, or only dur-
ing unlocking.
• The confirmation function (this indicates
locking or unlocking of the doors with
1
the blink of the turn-signal lamps) can be
deactivated.
• The number of times the turn-signal
lamps are flashed by the confirmation
function can be changed.
l
The keyless entry system does not operate in
the following conditions:
• The key is left in the key cylinder.
• The door is open.
l
The remote control switch will operate with-
in approximately 4 m from the vehicle. How-
ever, the operating range of the remote con-
trol switch may change if the vehicle is loca-
ted near a power station, or radio/TV broad-
casting station.
l
If either of the following problems occurs,
the battery may be exhausted.
• The remote control switch is operated at
the correct distance from the vehicle, but
the doors are not locked/unlocked in re-
sponse.
• The trunk lid cannot be opened.
1-24
• The indication lamp (4) is dim or does
not come on.
For further information, please contact
your MITSUBISHI MOTORS Author-
ized Service Point.
If you replace the battery yourself, refer
to "Procedure for replacing the remote
control switch battery" on page 1-24.
l
If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
l
If you wish to add a remote control switch,
please contact your MITSUBISHI MOTORS
Authorized Service Point.
A maximum of 4 remote control switches are
available for your vehicle.
Setting of door unlock function (vehicles equip-
ped with the central door lock switch)
E00310400027
The door unlock function can be set to the follow-
ing two conditions.
Each time the door unlock function is set, a chime
will sound to tell you the condition of the door un-
lock function.
Number of
Condition
chimes
One chime
All doors unlock
Two chimes
Driver's door unlock only
1. Turn the ignition switch to the "LOCK" posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Place the combination headlamps and dipper
switch in the "OFF" position, and leave the
driver's door open.
OG1E12E1
3. Press the LOCK switch (1) for 4 to 10 sec-
onds and press the UNLOCK switch (2) dur-
ing this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of press-
ing the LOCK switch in step 3.
NOTE
l
On vehicles equipped with Mitsubishi Multi-
Communication System (MMCS), screen op-
erations can be used to make the adjustment.
Refer to the separate owner's manual for de-
tails.
Procedure for replacing the remote control switch
battery
E00309600016
1. Before replacing the battery, remove static
electricity from your body by touching a met-
al grounded object.
2. With the MITSUBISHI mark facing you, in-
sert the cloth-covered tip of a straight blade
(or minus) screwdriver into the notch in the
case and use it to open the case.
Hide quick links:
Advertisement
Chapters
Table of Contents
