Mitsubishi Lancer Owner's Manual page 57
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Locking and unlocking
Changing the security alarm settings
It is possible to set the security alarm to the "ac-
tive" mode or "inactive" mode.
Follow the procedure below.
1. Turn the ignition switch to the "LOCK" posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
1
2. Place the lamp switch in the "OFF" position,
and leave the driver's door open.
3. Pull the windscreen wiper and washer switch
towards you and hold it there.
1-34
(Since the ignition switch is in the "LOCK"
position, washer fluid will not be sprayed.)
E00301600270
4. After approximately 10 seconds, the buzzer
will make a sound. Keep the windscreen wip-
er and washer switch pulled towards you.
(If the windscreen wiper and washer switch
was released, the setting change mode would
be cancelled. To start over, perform the pro-
cedure again from step 3.)
5. When the buzzer stops, with the windscreen
wiper and washer switch still pulled towards
you, press the UNLOCK switch (A) on the
OG1E12E1
keyless entry switch to select the security
alarm settings mode.
Except for vehicles with the keyless operation system
Vehicles with the keyless operation system
The settings mode can be toggled by press-
ing the UNLOCK switch. The mode can be
confirmed from the number of times the buz-
zer sounds.
Number of
times the buz-
Security alarm settings mode
zer sounds
1
Alarm inactive
2
Alarm active
Hide quick links:
Advertisement
Chapters
Table of Contents
