Mitsubishi Lancer Owner's Manual page 58
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
6. Any of the following operations can be used
to terminate the system settings change mode.
• Releasing the windscreen wiper and
washer switch.
• Closing the driver's door.
• Inserting the key into the ignition
switch.
• Placing the lamp switch in any posi-
tion other than "OFF".
• Allowing 30 seconds to pass without
making any changes to the settings.
• Push the ignition switch to the
"LOCK" (PUSH ON) position (Vehi-
cles with keyless operation system).
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand,
please
consult
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the "active" mode.
Setting the system
E00301700633
Follow the procedure below to set the system to the
system armed mode.
1. Turn the ignition switch to the "LOCK" posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors,
trunk lid and bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver's or
front passenger's door lock/unlock switch
(B) in order to lock all the doors.
Except for vehicles with the keyless operation system
Vehicles with the keyless operation system
your
Driver's and passenger's door lock/unlock switches*
OG1E12E1
Locking and unlocking
By locking the vehicle using the keyless en-
try system or the keyless operation system,
the system preparation mode is activated.
The security indicator (C) in the audio panel
blinks for confirmation.
NOTE
l
The system preparation mode is not activated
when the doors have been locked using a
method other than the keyless entry system
or the keyless operation function (namely a
key or the central door lock switch).
l
If the bonnet is open, the security indicator il-
luminates, and the system does not enter the
system armed mode.
When the bonnet is closed, the system enters
the preparation condition, and after approxi-
mately 20 seconds the system enters the sys-
tem armed mode.
4. After approximately 20 seconds, when the
blinking of the security indicator starts to
slow down, the system armed mode goes in-
to effect.
The security indicator continues to blink dur-
ing the system armed mode.
1
1-35
Hide quick links:
Advertisement
Chapters
Table of Contents
