Mitsubishi Lancer Owner's Manual page 76
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Driver's seat belt reminder/warning
lamp and display
E00409800598
Warning lamp
Warning display type 1
Warning display type 2
A tone and warning lamp are used to remind the
driver to fasten the seat belt.
If the ignition switch is set to the "ON" position
without the driver's seat belt being fastened, a warn-
ing lamp will blink and a buzzer will sound for ap-
proximately 6 seconds to remind you to fasten your
seat belt.
If you then drive with the seat belt unfastened for
longer than a minute from when the ignition switch
was turned on, the warning lamp will come on and
blink repeatedly and the tone will sound intermit-
tently.
The warning lamp and the tone alarm will stop af-
ter approximately 90 seconds.
If you then repeatedly stop and start your vehicle
with the seat belt unfastened, the warning lamp/dis-
play and tone will remind you to fasten your seat
belt every time the vehicle starts moving.
You will also be reminded to fasten your seat belt
in this way when you remove your seat belt while
driving. The warning lamp and the tone alarm go
off when the seat belt is fastened.
NOTE
l
At the same time, "FASTEN SEAT BELT"
is displayed on the information screen in the
multi-information display.
Front passenger seat belt warning
lamp*
E00411600245
The front passenger seat belt warning lamp is loca-
ted on the instrument panel.
Type 1
Type 2
The lamp comes on when a person sits on the front
passenger seat but does not fasten the seat belt. It
goes off when the seat belt is subsequently fastened.
OG1E12E1
Seat and seat belts
WARNING
l
Do not install any accessory or sticker
that makes the lamp difficult to see.
Adjustable seat belt anchor (front
seats)
E00405000420
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob
(A) depressed. To move the anchor up, slide it with-
out depressing the lock knob (A).
Anchor down
Anchor up
WARNING
l
When adjusting the seat belt anchor, set
it at a position that is sufficiently high so
that the belt will make full contact with
your shoulder but will not touch your neck.
2
2-11
Hide quick links:
Advertisement
Chapters
Table of Contents
