Removing A System Fan - Dell PowerEdge 6850 System Installation Manual

Hide thumbs Also See for PowerEdge 6850:

Table of Contents

6. Install the new system battery with the side labeled "+" facing up. See Figure 6-1.

NOTE:

The side of the battery labeled "+" must face toward the open side of the battery socket.

7. Install the new system battery.

a. Support the battery connector by pressing down firmly on the positive side of the connector.

b. Hold the battery with the "+" facing up, and slide it under the securing tabs at the positive side of the connector.

c. Press the battery straight down into the connector until it snaps into place.

8. Replace the memory riser cards A and B. See

9. Close the system. See

"Closing the

10. Enter the System Setup program to confirm that the battery operates properly.

11. From the main screen, select System Time to enter the correct time and date.

12. Re-enter any system configuration information that is no longer displayed on the System Setup screens, and then exit the System Setup program.

13. To test the newly installed battery, see

Fans

The system's four hot-plug fans (fans 1 through 4) provide cooling for the inside of the system. See Figure 6-2.

NOTICE:

In the event of a problem with a particular fan, the fan's number is referenced by the system's management software, allowing you to easily

identify and replace the proper fan.

Figure 6-2. System Fans

Removing a System Fan

"Removing and Installing a Non–Hot-Pluggable Memory Riser

System" in "Troubleshooting Your System."

"Troubleshooting the System

Battery" in "Troubleshooting Your System."

Card."

Table of Contents