Converting A Standard Cisco Asr 901 To Satellite - Cisco ASR 9000 Series System Configuration Manual
Aggregation services router nv
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Installing a Satellite
In the case of simple ring topology, the image must be transferred to all the satellites using install nv
Note
satellite transfer <range of satellites> command followed by install nv satellite activate <range of
satellites> command. You cannot use only the install nv satellite activate command in the case of simple
ring topology.
RP/0/RSP0/CPU0:sat-host# install nv satellite 100 transfer
Install operation initiated successfully.
RP/0/RSP0/CPU0:sat-host#RP/0/RSP0/CPU0:May
%PKT_INFRA-ICPE_GCO-6-TRANSFER_DONE : Image transfer completed on Satellite 100
RP/0/RSP0/CPU0:sat-host# install nv satellite 100 activate
Install operation initiated successfully.
LC/0/2/CPU0:May
GigabitEthernet100/0/0/28, changed state to Down
RP/0/RSP0/CPU0:May
removed
If the activate command is run directly, then the software image is transferred to the satellite and also
Note
activated.
RP/0/RSP0/CPU0:sat-host# install nv satellite 101 activate
Install operation initiated successfully.
RP/0/RSP0/CPU0:sat-host#RP/0/RSP0/CPU0:May
%PKT_INFRA-ICPE_GCO-6-TRANSFER_DONE : Image transfer completed on Satellite 101
RP/0/RSP0/CPU0:May
Image install completed on Satellite 101
RP/0/RSP0/CPU0:May
removed
Note
For the satellite image upgrade to work, you must ensure that the management-plane CLI is not configured
on the Cisco ASR 9000 Series Router . If it is configured, then you need to add this exception for each of
the 10GigE interfaces, which are the satellite ICLs.
Ensure that the tftp homedir, tftp vrf default ipv4 server homedir disk0 is not configured on the host when
using manual IP default configuration, because this may cause the image transfer to fail.
You can include the exception using this CLI:
control-plane
management-plane
inband
!
!
interface TenGigE0/0/0/5
allow TFTP
If you do not include this exception, then the image download and upgrade fails.
Converting a Standard Cisco ASR 901 to Satellite
In order to convert a standard Cisco ASR 901 Router to Satellite, see
ASR 901 Series Aggregation Services Router as a Satellite
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
54
3 20:13:50.363 : ifmgr[201]: %PKT_INFRA-LINK-3-UPDOWN : Interface
3 20:13:50.811 : invmgr[254]: %PLATFORM-INV-6-OIROUT : OIR: Node 100
3 20:06:33.449 : icpe_gco[1146]: %PKT_INFRA-ICPE_GCO-6-INSTALL_DONE :
3 20:06:33.510 : invmgr[254]: %PLATFORM-INV-6-OIROUT : OIR: Node 101
<=== To enable TFTP on nV satellite ICL
Configuring the Satellite Network Virtualization (nV) System
3 20:12:46.732 : icpe_gco[1146]:
3 20:06:33.276 : icpe_gco[1146]:
Network Virtualization Using Cisco
Advertisement
Table of Contents
