Te Class Mapping - Cisco ASR 9000 Series Configuration Manual
Aggregation services router mpls
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing MPLS Traffic Engineering
Related Topics
Configuring an IETF DS-TE Tunnel Using RDM, on page 175
TE Class Mapping
Each of the eight available bandwidth values advertised in the IGP corresponds to a TE class. Because the
IGP advertises only eight bandwidth values, there can be a maximum of only eight TE classes supported in
an IETF DS-TE network.
TE class mapping must be exactly the same on all routers in a DS-TE domain. It is the responsibility of the
operator configure these settings properly as there is no way to automatically check or enforce consistency.
The operator must configure TE tunnel class types and priority levels to form a valid TE class. When the TE
class map configuration is changed, tunnels already up are brought down. Tunnels in the down state, can be
set up if a valid TE class map is found.
The default TE class and attributes are listed. The default mapping includes four class types.
Table 5: TE Classes and Priority
TE Class
0
1
2
3
4
5
6
7
Flooding
Available bandwidth in all configured bandwidth pools is flooded on the network to calculate accurate constraint
paths when a new TE tunnel is configured. Flooding uses IGP protocol extensions and mechanisms to determine
when to flood the network with bandwidth.
Flooding Triggers
TE Link Management (TE-Link) notifies IGP for both global pool and sub-pool available bandwidth and
maximum bandwidth to flood the network in these events:
OL-28381-02
Class Type
0
1
Unused
Unused
0
1
Unused
Unused
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Flooding
Priority
7
7
—
—
0
0
—
—
123
Advertisement
Table of Contents
