Cisco ASR 9000 Series Configuration Manual page 239
Aggregation services router mpls
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing MPLS Traffic Engineering
Command or Action
Step 5
exit
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-if)# exit
Step 6
exit
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)# exit
Step 7
interface tunnel-tetunnel-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
tunnel-te 2
Step 8
ipv4 unnumbered type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4
unnumbered Loopback0
Step 9
path-option preference-priority{ dynamic | explicit
{identifier | name explicit-path-name}}
Example:
RP/0/RSP0/CPU0:router(config-if)# path-option
1 explicit name backup-srlg
Step 10
destination ip-address
Example:
RP/0/RSP0/CPU0:router(config-if)# destination
192.168.92.125
Step 11
exit
Example:
RP/0/RSP0/CPU0:router(config-if)# exit
Step 12
explicit-path {identifier number [disable | index]}{
name explicit-path-name}
Example:
RP/0/RSP0/CPU0:router(config)# explicit-path
name backup-srlg-nodep
OL-28381-02
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring the Shared Risk Link Groups
Purpose
Exits the current configuration mode.
Exits the current configuration mode.
Configures an MPLS-TE tunnel interface.
Assigns a source address to set up forwarding on the new
tunnel.
Sets the path option to explicit with a given name (previously
configured) and assigns the path ID. Identifier range is 1 to
4294967295.
You can use the dynamic option to dynamically
Note
assign path.
Assigns a destination address on the new tunnel.
• Destination address is the remote node's MPLS-TE
router ID.
• Destination address is the merge point between backup
and protected tunnels.
Note
When you configure TE tunnel with multiple
protection on its path and merge point is the same
node for more than one protection, you must
configure record-route for that tunnel.
Exits the current configuration mode.
Enters the explicit path configuration mode. Identifer range
is 1 to 65535.
223
Advertisement
Table of Contents
