Configuring Destinations For The Tunnel Interface - Cisco ASR 9000 Series Configuration Manual
Aggregation services router mpls
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Configuring Point-to-Multipoint TE
Command or Action
Step 7
show mrib ipv6 route source-address
Example:
RP/0/RSP0/CPU0:router# show mrib ipv6 route ff35::1
Related Topics
Enabling Multicast Routing on the Router, on page 228
Configuring Destinations for the Tunnel Interface
Perform this task to configure three destinations for the tunnel interface for Point-to-Multipoint (P2MP).
These variations are listed to ensure that the destination and path option configurations are separate from the
tunnel interface.
• Different path option is used for different destinations. This task shows three destinations.
• Explicit path option is based on an ID or a name.
• Default path option is similar to the Point-to-Point (P2P) LSP.
Before You Begin
These prerequisites are required to configure destinations for the tunnel interface.
• Multicast routing must be enabled on both the tunnel-mte interface and customer-facing interface from
• Static-group must be configured on the tunnel-mte interface to forward specified multicast traffic over
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
232
the source.
P2MP LSP.
Implementing MPLS Traffic Engineering
Purpose
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Verifies the multicast static mapping.
OL-28381-02
Advertisement
Table of Contents
