Table of Contents
Advertisement
Authentication type
●
the authentication type between your device and
the WLAN access point device.
WEP key settings
— Enter
●
(length of the key),
WEP key format (ASCII
Hexadecimal), and
the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2
— Select the means of authentication:
●
EAP
to use an extensible authentication protocol
(EAP) plug-in, or
Pre-shared key
Complete the appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
●
password must be entered on the WLAN access
point device.
WPA2 only mode
— Only WPA2 enabled devices
●
are allowed to establish a connection in this mode.
Advanced WLAN settings
Select
Options
Advanced settings
>
following:
IPv4 settings
— Enter the IP address of your
●
device, the subnet IP address, the default gateway,
and the IP addresses of the primary and secondary
© 2008 Nokia. All rights reserved.
— Select
Open
or
Shared
WEP encryption
WEP key
(the WEP key data in
to use a password.
— Enter the settings as
— Enter a password. The same
and from the
for
DNS servers. Contact your internet service provider
for these addresses.
IPv6 settings
●
Ad-hoc channel
●
or
channel number (1-11) manually, select
defined.
Proxy server address
●
proxy server.
Proxy port number
●
number.
Packet data settings
Press
, and select
Connection
The packet data settings affect all access points using
a packet data connection.
Packet data connection
●
available
packet data, the device registers to the packet data
network. Starting an active packet data connection
(for example, to send and receive e-mail) is quicker.
If there is no packet data coverage, the device
periodically tries to establish a packet data
connection. If you select
uses a packet data connection only if you start an
application or action that needs it.
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for the
— Enter the proxy port
Tools
Settings
>
Packet
data.
>
— If you select
and you are in a network that supports
When
needed, the device
Settings
User
>
When
169
Advertisement
Table of Contents
