Table of Contents
Advertisement
5. Verify that the weight label is installed on the 2104 Model DS4. See Figure 5.
Figure 5. 2104 Model DS4 weight label
CAUTION:
If a 2104 Model DS4 is fully loaded with 14 drives and two power supplies, its
total weight exceeds 32 Kg (70.5 lbs). You must remove at least six drives from
the 2104 Model DS4 before you lift it or install it into a rack or 2104 Model TS4.
This reduces the total weight to less than 32 Kg (70.5 lbs) and the
DS4
injury.
Attention:
If you have data stored on the drives, label the drives before you remove
them. When you replace the drives, install each one in the same drive bay
from which you removed it. Failure to do so could result in a loss of data.
6. Verify that the standby condition label is installed on the 2104 Model DS4. See
Figure 6. Standby condition label
xiv
Expandable Storage Plus 2104 Model DS4 Installation Guide
CAUTION:
This unit weighs over 32 Kg (70.5 lbs). Refer to manuals. (4)
Refer to manuals
32 Kg (70.5 lbs)
SC000220
can then be safely handled by two people. Failure to do so can result in
> 18 Kg (37 lbs)
> 32 Kg (70.5 lbs)
Figure 6.
CAUTION:
A standby condition is indicated by the symbol to the right of the DC
directly above the switch, SW1. When SW1 is toggled to the right position
directly under the standby symbol, the unit's ac-power is not shut off. (7)
2104 Model
SC000334
Advertisement
Table of Contents
