Sony STR-DA5300ES Operating Instructions Manual page 143
Hide thumbs
Also See for STR-DA5300ES:
- Operating instructions manual (310 pages) ,
- Service manual (260 pages) ,
- Quick setup manual (2 pages)
Table of Contents
Advertisement
Reference sections for clearing
the memory
For other messages, refer to "Message list after
auto calibration measurement" (page 51 ),
"XM Radio message list" (page 92), "SIRIUS
Satellite Radio message list" (page 92) and
"DIGITAL MEDIA PORT message list"
(page 97).
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of speakers and turn
on the power again.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
»
Q.
Q.
;::;:
0"
:::J
~
5'
0'
3
III
-
0 "
:::J
..
IIDepending on the sound tield settings and the
source, there may
be
no sound output.
21Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode I) 2)
(8 ohms 20 Hz - 20 kHz,
THDO.09%):
120W
+
120W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz - 20 kHz,
THDO.15%):
120W
+
120W
Reference Power Output
(80hms I kHz, THDO.7%)
FRONT 2 L
now
+
(30W
CENTER 2 ): 130 W
SURROUND 2
L
130W
+
130 W
SURROUND BACK2l:
130W
+
130 W
Reference Power Output
(40hms 1kHz, THDO.7%)
FRONT 2 L
120W
+
(20W
CENTER 2L 120 W
SURROUND 2 ):
120 W
+
120 W
SURROUND BACK 2 ):
120 W
+
120 W
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 - 20,000 Hz; rated 120 walls per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwalls to rated output.
See
To clear
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, i
I'
they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. I
I'
the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 40).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
All memorized sellings
page 39
continued-----
143
GB
Advertisement
Table of Contents
