Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
During the spring and autumn, or after an interruption to the
cutting schedule, the grass will be longer and thicker. If the
motor continually slows down while cutting, try setting the
wheels for a higher cutting height. Excessive motor loading
can result in uneven cutting, quicker discharge of the battery
and can cause the motor to overload which stops the motor.
There are three good ways to enhance your lawn's
appearance: Vary the mowing direction frequently; mow
horizontally on hillsides; (this is also a good safety practice)
and do not forget to overlap the mowing path on each pass.
Always mow grass so that clippings are discharged onto cut
lawn. This will keep your lawn looking fresh by avoiding 'cut
grass' build-up which will eventually turn brown and appear
ugly. This method also preserves your battery charge,
making sure that you get the most from your Black & Decker
cordless power mower.
During the spring and autumn seasons when the grass is
longer and thicker, you can use your mower without the
battery being fully charged (ie the green charge indication
light is on). This will enable you to perform short cutting
tasks, however we don't recommend that this is done
frequently. The battery and mower perform much better
when fully charged.
CUTTING EXPECTATIONS
Variation is based on wetness, length of grass and
pushing pace of the mower
Cut
Un-cut
Heavy
2
m
conditions
350 - 750
Troubleshooting
If your appliance is not operating properly, follow the
instructions below. If this does not solve the problem, please
contact your local Black & Decker repair agent.
Problem
Solution
Mower does not run
Check to make sure that the safety
when bail bar is
key has been installed and is fully
activated
seated and that the button on the
switch housing is completely
pressed.
Release the bail bar to turn the
mower off. Remove the safety key,
turn the mower over and check that
the blade is free to turn.
14
Medium
Light
conditions
conditions
750 - 1100
900 - 1400
Problem
Solution
Check that the battery is free of
debris and is connected properly.
Is the battery fully charged? Plug in
the charger and wait for the green
light to come on.
Motor stops while
Release the bail bar to turn the
mowing
mower off. Remove the safety key.
Turn the mower over and check that
the blade is free to turn.
Raise the cutting height of the
wheels to the highest position and
start the mower.
Check that the battery is free of
debris and is connected properly.
Is the battery fully charged? Plug in
the charger and wait for the green
light to come on.
Slow down or raise the cutting
height.
Mower runs but
Is the battery fully charged? Plug in
cutting performance
the charger and wait for the green
is unsatisfactory, or
light to come on.
does not cut the
Release the bail bar to turn the
entire lawn
mower off. Remove the safety key
and the battery pack. Turn the
mower over and check:
Wheel height adjustment may be set
too low for grass condition. Raise
cutting height.
Mower is difficult to
Raise the cutting height to reduce
push
drag on grass. Check each wheel for
free rotation.
Mower is abnormally
Release the bail bar to turn the
noisy and vibrates
mower off. Remove safety key and
the battery pack. Turn the mower on
its side and check the blade to make
sure it has not been bent or
damaged. If the blade is damaged,
replace with a Black & Decker
replacement blade. If the underside
of the mower is damaged, return the
mower to a Black & Decker
authorised service centre.
Blade for sharpness - keep
blade sharp.
Underside and discharge chute
for clogging.
Advertisement
Table of Contents
