Table of Contents
Advertisement
Available languages
Available languages
EXTEGRA IP 9000 FX
1.4
Important Safety Instructions
Read, follow, and retain all of the following safety instructions. Heed all warnings on the unit
and in the operating instructions before operation.
Caution!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DISCONNECT THE POWER SOURCE WHILE
!
INSTALLING THE CAMERA.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any
damages or losses caused by incorrect or improper installation.
Warning!
INSTALL EXTERNAL INTERCONNECTING CABLES IN ACCORDANCE TO NEC, ANSI/NFPA70
(FOR US APPLICATION) AND CANADIAN ELECTRICAL CODE, PART I, CSA C22.1 (FOR CAN
APPLICATION) AND IN ACCORDANCE TO LOCAL COUNTRY CODES FOR ALL OTHER
!
COUNTRIES. BRANCH CIRCUIT PROTECTION INCORPORATING A 20 A, 2-POLE LISTED
CIRCUIT BREAKER OR BRANCH RATED FUSES ARE REQUIRED AS PART OF THE BUILDING
INSTALLATION. A READILY ACCESSIBLE 2-POLE DISCONNECT DEVICE WITH A CONTACT
SEPARATION OF AT LEAST 3 mm MUST BE INCORPORATED.
Adjustment of controls - Adjust only those controls specified in the operating instructions.
Improper adjustment of other controls may cause damage to the unit.
Power cord and plug protection - Protect the power cord from being walked on or pinched,
particularly at plugs, and at the point of exit from the device.
For units intended to operate with 230 VAC, 50 Hz, the input and output power cord must
comply with the latest versions of IEC Publication 227 or IEC Publication 245.
Power disconnect - Units with or without ON/OFF switches have power supplied to the unit
whenever the power cord is inserted into the power source; however, the unit is operational
only when the ON/OFF switch is in the ON position. The power cord is the main power
disconnect device for switching off the voltage for all units.
HPoE: Use only approved HPoE devices. High Power-over-Ethernet can be connected at the
same time as a 24 VAC power supply.
If auxiliary power (24 VAC) and HPoE are applied simultaneously, the camera selects auxiliary
input and shuts off the HPoE.
Servicing - Do not attempt to service this device yourself. Refer all servicing to qualified
service personnel.
Bosch Security Systems
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
®
Installation Manual / Guide d'installation
Safety | en
5
2015.03 | 1.7 | F.01U.304.260
Advertisement
Chapters
Table of Contents
