Table of Contents
Advertisement
a) Mounting a wireless solar siren
Back-plate
Strobe
Figure 1
Back-plate holding
screw
Figure 2
Figure 3
Use the wall plugs and screws provided if
suitable for your particular building construction.
1.
Remove the holding screw from the base of
the unit and hinge off the front plate.
2.
Use the template provided to mark the
position of the four fixing holes on the
external wall.
3.
Drill mounting holes (7mm diameter, 25mm
minimum in depth) into the chosen wall.
4.
If a masonry wall, use the larger wall plugs
provided. Press each one into the 4 main
mounting holes.
5.
Screw the top 2 screws half way in.
6.
Place the back-plate to support itself from
Top
the top 2 screws through the key shape
mounting
holes at the top of the main control unit
holes
7.
Screw in and tighten the bottom two
mounting screws then tighten the top two
screws.
Bottom
mounting
8.
Change the dipswitches on the solar siren
holes
to a random combination. This ensures that
the siren transmits a unique code.
9.
First connect the 9V initial power up battery
inside the unit to the clip-on connectors.
Then connect the rechargeable battery to
the charging leads red to red (+) and black
to black (-). See figure 3.
10. Hinge the front cover locating tabs over the
top edge of the back-plate, and push the
base of the siren cover in place. The strobe
will flash momentarily, if not remove the
siren and replace it again, and secure the
lower fixing screw.
11. Press and hold button 1 on one of the
remote controls for 3 seconds. The strobe
will start flashing and the internal screamer
will start sounding. If not either the Wireless
Solar Siren unit or the Main unit need to be
relocated so that they are closer together.
Press button 2 to stop the siren sounding.
How to learn in the Solar Siren
Set the dipswitches on the Main Control Unit so
they are the same as the dipswitches on the
solar siren. Hold the ADD button down and turn
the Main Control Unit ON using the master key.
When you hear the solar siren beep, turn the
dipswitches on the Main Control Unit OFF.
23
Advertisement
Table of Contents
