Table of Contents
Advertisement
2.2.10 Compact Hard Wired Siren
a) Mounting a Compact Hard Wired External Siren – W24-PLUG
Remove screws
located on both
sides of the cover
Figure 1
Align siren
unit & mark
3 mounting
holes.
Figure 2
Figure 3
Remove the 2 screws from the main unit
as per Fig 1. and remove front cover from
the siren.
Align the siren backing plate in your chosen
location and mark the 3 mounting holes as per
Fig 2.
Drill mounting holes (7mm diameter, 25mm
minimum in depth) into the chosen wall.
If a masonry wall, use the green star plugs.
Press each one into the 3 main mounting
holes.
Make a 12mm hole and feed the 20m of cable
through the wall and to the main control
module.
Fit the siren cover back on to the backing
plate a fasten with screws
Plug the cable into the main control unit as
per Fig3.
25
Advertisement
Table of Contents
