Table of Contents
Advertisement
5.4.3 To Add Phone Numbers To The System
The Watchguard SMS 2010 alarm is able to be programmed with up to 5 different mobile phones, so when
the alarm is armed or put in to panic mode and activates, it will send an SMS message to each of the phone
numbers in the systems memory. Instructions on adding additional numbers, such as a child or spouse's
number, are shown below.
BY SMS ONLY
By typing your 6-digit PIN code and WRITEPHONEXYYYY from a mobile phone, you can
add a mobile phone number to the alarm system. The mobile phone number 'YYYY' will go
in location 'X'. (X must be between 1 – 5)
PIN CODE
LOCATION: 1 to 5
000000
⇓
⇓
WRITEPHONEXYYYY
EG: 000000WRITEPHONE30409986655
⇑
⇑
COMMAND
NEW PHONE NUMBER
This will add the phone number 0409986655 to
location 3 in the alarm.
Ph Numbers:
You will then receive a reply SMS message back
1.0409986655 2.Not
stating all the phone numbers in the alarm
Used 3.0409599939
systems memory.
4.Not Used
5.0414222345
E.G.
Phone Numbers:
1: 0409986655, 2: Not Used, 3: 0409986655, 4: Not Used, 5: 0414222345
5.4.4 To Read Phone Numbers From The System
This function allows you to see what numbers are programmed into the system already. The Watchguard
SMS 2010 will tell you what location the number is programmed into (1 to 5) and if you have any free spaces
to add additional numbers by saying 'not used'.
BY SMS ONLY
Type your PIN number and READPHONE, and send it to your alarm. You can find out the
different mobile numbers that are programmed into the system.
You will then receive a reply SMS message,
000000
stating all the phone numbers in the alarm
READPHONE
system's memory.
E.G.
Phone Numbers:
1: 0409986655, 2: 040411689, 3: Not Used, 4: Not Used, 5: 0414222345
40
Advertisement
Table of Contents
