Table of Contents
Advertisement
5.4.5 To Erase Phone Numbers From The System
The Watchguard SMS 2010 can erase numbers from its memory via SMS. This is useful when a phone
number has changed and a new number needs to be programmed into the system – the old number must first
be erased. Follow the steps below to erase an old or undesired number from you alarm system.
BY SMS ONLY
There are 5 memory locations for mobile phones. Type your PIN code and
ERASEPHONEX, and send it to your alarm you can erase the mobile phone number that is
stored in the location identified by 'X' in the alarm system.
EG: 000000ERASEPHONE3 – will erase the
phone number stored in location 3 in the alarm
000000
memory.
ERASEPHONE3
You will then receive a reply SMS message back
stating all the phone numbers that are stored in
the alarm systems.
E.G.
Phone Numbers: 1: 0409986655, 2: Not Used, 3: Not Used, 4: Not Used, 5:
0414222345
5.4.6 SMS Controlled Output
The Watchguard SMS 2010 incorporates an onboard SMS controlled open collector output
that can be switched on and off with a simple message.
OUTPUTON/OFF: Type your PIN number and OUTPUTON from a mobile phone, and send
it to the alarm to activate the output. Once the message is sent the alarm will respond with
"Output turned on." To turn the output off send OUTPUTOFF and the alarm will respond
with "Output turned off."
000000
000000
OUTPUTON
OUTPUTOFF
41
Advertisement
Table of Contents
