Can't Access Lan Interface; Can't Access Wan Interface - D-Link DSL-2600U User Manual

Adsl2+ wireless router

Hide thumbs Also See for DSL-2600U:

Table of Contents

If you have changed the password and forgotten it, you will need to upload the default

configuration file. This will erase all custom configurations and restore factory defaults,

including the password.

Press the RESET button for five seconds, and then release it. When the SYS LED

begins to blink, the defaults have been restored and the router restarts. Or refer

to the Resetting the router section for uploading a configuration file via console port.

The default username is "admin". The default password is "admin". The Password and

Username fields are case-sensitive. Make sure that you use the proper casing.

It is highly recommended to change the default username and password. Make sure

you record the username and password in a save place.

Can't Access LAN Interface

I cannot access the router from the LAN or ping any computer on the

LAN.

STEPS

Check the Ethernet LEDs on the front panel. A LAN LED should be on if the port is

connected to a computer or hub. If the 10M/100M LEDs on the front panel are both off.

Make sure that the IP address and the subnet mask of the router and your

computer(s) are on the same subnet.

Initialization of the ADSL connection failed.

STEPS

Check the cable connections between the ADSL port and the wall jack. The DSL LED

on the front panel of the router should be on.

Check that your VPI, VCI, type of encapsulation and type of multiplexing settings are the

same as that you obtained from your telephone company and ISP.

Restart the router. If you still have problems, you may need to verify your VPI,

VCI, type of encapsulation and type of multiplexing settings with the telephone company

and ISP.

CORRECTIVE ACTION

Table of Contents

Show Quick Links

Table of Contents