Table of Contents
Advertisement
Available languages
Available languages
TO REMOVE CABLES, REVERSE ORDER-
1. BLACK cable first from chassis and then
from the fully charged batterY.
2. RED cable last from both batteries.
Weak or
Dead
Battery
REPLACING BATTERY
n_asWARNING: Do not short battery termi-
by allowing awrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hood to raised position.
2, Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
batter,.7from tractor.
4, Installnewbatterywithterminals
insame
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) batteryterminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACK grounding cable to
negative (-) batterYterminalwith remain-
ing bolt and nut. Tighten securely
8. Close. hood.
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2.
Remove buib holder from the hole in the
backside
of the grill.
3.
Replace b_lb in holder and install bulb
holder securely back into the hole in the
backside
of the grill.
4, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD & GRILL ASSEMBLY
1. Raise hood.
2, Unsnap headlight wire connector,
3. Remove retainer clip and washer from
right hand pivot pin.
4. Stand in front of tractor. Grasp hood at
sides and slide left removing hood from
pivot pins and lift hood off of tractor,
5. When replacing hood, reconnect the
headlight wire connector, and reinstall
the washer and retainer clip on the
right hand pivot pin,
LeftPivotPin
Washer
Retainer
_ight Pivot
Pin
Headlight
Wire
Connecter
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at
the factory and adjustment should not be
necessary. If adjustment is necessary, see
engine manual.
26
- Quick Links:
- Transaxle Maintenance
Hide quick links:
Advertisement
Table of Contents
