Installing A Dvd Drive - Cisco UCS C210 Installation And Service Manual
Hide thumbs
Also See for UCS C210:
- Installation and service manual (124 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Chapter 3
Maintaining the Server
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
c.
d.
Install a new power supply:
Step 2
a.
b.
c.
Figure 3-7
1
Installing a DVD Drive
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and navigate to the page for your server
model and generation:
http://www.cisco.com/en/US/prod/ps10265/ps10493/c-series_part_numbers.html
Warning
Class 1 laser product.
Statement 1008
To replace a DVD drive, follow these steps:
Remove a DVD drive:
Step 1
a.
b.
c.
Caution
d.
OL-20887-02
Push the release lever toward the center of the power supply and pull on the power supply handle to
disengage it from the backplane (see
Remove the power supply from the bay.
Insert the new power supply into the bay and push it in until the release lever clicks and locks.
Replace the power cord to the new power supply.
Press the Power button to return the server to main power mode.
Removing and Replacing a Power Supply
2
1
Power supply handle
Power off the server as described in the
page
3-7.
Disconnect all power cords from the power supplies.
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Remove the top cover as described in the
on page
3-9.
Figure
3-7).
2
Release lever
"Shutting Down and Powering Off the Server" section on
"Removing and Replacing the Server Top Cover" section
Cisco UCS C210 Server Installation and Service Guide
Installing or Replacing Components
3-15
Advertisement
Table of Contents
