Table of Contents
Advertisement
Providing power to the SAN768B-2
DANGER
To provide power to the SAN768B-2:
1. Connect the AC power cords to the power supply assemblies. Two or four
2. Connect the power cords to power sources with voltage of 200 to 240 VAC, 47
3. Turn the AC power switches on the power supplies to ON (|). The AC power
4. The SAN768B-2 performs a power-on self-test (POST) each time it is powered
Establishing a serial connection and logging on to the SAN768B-2
To establish a serial connection and log on to the SAN768B-2:
1. Verify that the SAN768B-2 is powered on and that POST is complete by
2. Remove the shipping cap from the CONSOLE port on the active CP. The active
3. Access the SAN768B-2 using a terminal emulator application (such as
4. Disable any serial communication programs running on the workstation (such
5. Open the terminal emulator application and configure as follows:
Use the supplied power cords. Ensure the facility power receptacle is the
correct type, supplies the required voltage, and is properly grounded. (D004)
power cords are required depending on electrical service.
Attention: A chassis fully loaded with 16 Gbps port blades (384 ports total)
should be supplied with four power supplies connected to 200-240 VAC lines.
to 63 Hz (two or four power cords).
switches light green when switched on and power is supplied.
on. POST takes approximately 10 minutes and is complete when indicator light
activity indicates the operational state. For information about LED patterns, see
Chapter 4, "Monitoring system components," on page 45.
You can bypass POST by using the fastBoot command. You can also disable
POST for successive reboots on the SAN768B-2 using the diagDisablePost
command.
Attention: To prevent a potential IP address conflict, do not connect the
SAN768B-2 to the network until the IP addresses are configured.
Note: To power off the SAN768B-2, see "Powering off the SAN768B-2" on page
44.
verifying that all power LED indicators on the port, control processor, and core
switch blades display a steady green light.
CP blade is indicated by an illuminated (blue) LED. Use the serial cable
provided with the SAN768B-2 to connect the CONSOLE port on the active CP
to a computer workstation.
Attention: The CONSOLE port is intended primarily for the initial setting of
the IP address and for service purposes.
HyperTerminal in a Windows environment or TERM in a UNIX environment).
as synchronization programs).
v For most Microsoft Windows systems, use the following configuration
parameters.
Bits per second: 9600
Data bits:
8
Chapter 3. Starting and configuring the SAN768B-2
33
Advertisement
Table of Contents
Troubleshooting
