Table of Contents
Advertisement
2. Remove the cables from the cable management comb and rearrange the cables
3. Unscrew and save the four screws holding the comb to the chassis (see
4. Remove the cable management comb.
Figure 24. Cable management comb
Installing a cable management comb
Complete the following steps to install a cable management comb.
1. Align the comb with the four screw holes on the chassis.
2. Position, insert, and tighten the four screws to secure the cable management
3. Arrange the cables along the cable management comb.
4. Replace the chassis door.
Removing and installing port and application blades
This section describes how to remove and install port and application blades.
Attention: A filler panel should be removed only when being replaced with
another blade or a filler panel. Any slot that is not occupied by a blade should be
occupied by a filler panel to ensure correct cooling of the chassis and protection
from dust.
around the comb.
Figure 24). Support the comb to prevent it from falling.
comb to the chassis.
Chapter 5. Removing and installing components
69
Advertisement
Table of Contents
Troubleshooting
