Table of Contents
Advertisement
6. Diagnostic Program
6.1 Power-ON Plug & Play Test
The operation steps for a power-on Plug & Play test are as follows:
Step 1: Power-off PC
Step 2: Install PCI-1002 without any extra external connector
Step 3: Power-on PC and check the PC screen very carefully
Step 4: The PC will perform a self-test first
Step 5: Detect the non-PCI physical devices installed in the system
Step 6: Show the information of these device in screen
Step 7: Detect the PCI Plug & Play devices installed in the system
show all PCI-device information
There will be a PCI device with vendor_ID=1234, device_ID=1002 (PCI-
1002)
If the Plug & Play ROM-BIOS detects the PCI-1002 card during the power-on
time, the software driver of DOS,and Windows 95/NT/2000/XP will function well
later. If the Plug & Play ROM-BIOS can't find the PCI-1002, all software drivers
will not function. Therefore the user must make sure that the power-on procedure
is correct.
6.2 Driver Plug & Play Test
Step 1: Power-off PC.
Step 2: Install PCI-1002 without any extra external connectors.
Step 3: Power-on PC. Run DEMO7.EXE.
Step 4: The I/O base address of all PCI-1002 installed in the system will be
shown in screen.
Step 5: Is the total number of boards correct?
Step 6: Install a 20-pin flat cable into one of these PCI-1002 cards.
Step 7: One card's D/O=D/I
number.
Step 8: Repeat the previous two steps to find the physical card number for each
board.
PCI-1002 User's Manual (Ver. 2.4, Mar./2004, PPH-015-24) ---- 43
check here carefully
This is the physical card number. Remember this
Advertisement
Table of Contents
