System > System Log Configuration > System Log Settings; System > System Log Configuration > System Log Server - D-Link DGS-1210/ME User Manual
Metro ethernet switch series
Hide thumbs
Also See for DGS-1210/ME:
- Reference manual (522 pages) ,
- Hardware installation manual (53 pages) ,
- Hardware installation manual (52 pages)
Table of Contents
Advertisement
4 Configuration
History Size (1-500): The maximum number of entries listed in the history log used for notification. Up to
500 entries can be specified.
Click Apply for the changes to take effect.
To change MAC notification settings for a port or group of ports on the Switch, configure the following
parameters. , then click the Apply button.
From Port / To Port: Select a port or group of ports to enable for MAC notification using the pull-down
menus.
State: Enable MAC Notification for the ports selected using the pull-down menu.
System > System Log Configuration > System Log Settings
System Logs record and manage events, as well as report errors and informational messages. Message
severity determines a set of event message will be sent. Click Enable so you can start to configure the
related settings of remote system log server, then press Apply for the changes to take effect.
Save Mode: Use this drop-down menu to choose the method that will trigger a log entry. You can choose
between On Demand, Time Interaval and Log Trigger.
Minutes: Enter a time intervel, in minutes, for which user would like a log entry to be made.
System > System Log Configuration > System Log Server
The user can send Syslog messages to up to four designated servers using the System Log Server. It
supports maximum 500 system log entries. To set the System Log Server configuration, click Apply.
Server ID: Specifies the Server ID. The field range is 1-4.
Severity: Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning - The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Server IPv4 Address: Specifies the IPv4 address of the system log server.
Server IPv6 Address: Specifies the IPv6 address of the system log server.
Facility: Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 ~ Local 7).
UDP Port: Specifies the UDP port to which the server logs are sent. The possible range is 6000 – 65535,
and the default value is 514.
Status: Specifies the status is enable or disable.
Figure 4.40 – System > System Log Configuration > System Log Settings
Figure 4.41 - System > System Log Configuration > System Log Server
DGS-1210 series Metro Ethernet Managed Switch User Manual
2
5
2
5
Hide quick links:
Advertisement
Table of Contents
