free hit counter
Napoleon MIRAGE 605 Assembly And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Napoleon Manuals
  4. Grill
  5. MIRAGE 605
  6. Assembly and operating instructions manual
Napoleon MIRAGE 605 Assembly And Operating Instructions Manual

Napoleon MIRAGE 605 Assembly And Operating Instructions Manual

Outdoor stainless steel gas grill
Hide thumbs Also See for MIRAGE 605:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Manual, Assembly and Operating Instructions Manual
APPLY SERIAL NUMBER LABEL FROM CARTON
Serial No.
XXXXXX000000
MODEL NO.
ASSEMBLY AND OPERATING INSTRUCTIONS
MIRAGE 605
OUTDOOR STAINLESS STEEL GAS GRILL
FOR OUTDOOR USE ONLY
READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING GRILL.
DO NOT TRY TO LIGHT THIS APPLIANCE WITHOUT READING LIGHTING INSTRUCTIONS
SECTION OF THIS MANUAL
NAPOLEON APPLIANCE CORPORATION.,
214 BAYVIEW DR., BARRIE, ONTARIO, CANADA L4N 4Y8 PHONE: (705)726-4278
FAX: (705)725-2564 EMAIL: care@nac.on.ca WEB SITE: www.napoleongrills.com
N415-0157CE FEB 03/09

Advertisement

Table of Contents
loading

Related Manuals for Napoleon MIRAGE 605

Summary of Contents for Napoleon MIRAGE 605

  • Page 1 APPLY SERIAL NUMBER LABEL FROM CARTON Serial No. XXXXXX000000 MODEL NO. ASSEMBLY AND OPERATING INSTRUCTIONS MIRAGE 605 OUTDOOR STAINLESS STEEL GAS GRILL FOR OUTDOOR USE ONLY READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING GRILL. DO NOT TRY TO LIGHT THIS APPLIANCE WITHOUT READING LIGHTING INSTRUCTIONS SECTION OF THIS MANUAL NAPOLEON APPLIANCE CORPORATION.,...

  • Page 2: Conditions And Limitations

    NAPOLEON neither assumes, nor authorizes any third party to assume, on its behalf, any other liabilities with respect to the sale of this product. NAPOLEON will not be responsible for: over firing, blow outs caused by environmental conditions such as strong winds, or inadequate ventilation.

  • Page 3: Safety Precautions

    •Never use natural gas in a unit designed for liquid propane gas. •Never use lighter fluid in a gas grill. •Use charcoal briquettes only with a Napoleon charcoal tray designed for this unit. •Burner controls must be off when turning supply cylinder on.

  • Page 4: Gas Cylinder

    GAS CYLINDER CAUTION Use only gas cylinders which meet national and regional codes. The minimum cylinder size for butane units is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the appli- ance.

  • Page 5: Technical Data

    GAS HOSE • If the hose and regulator are not included by the manufacturer, then only hoses and regulators which meet national and regional codes are to be used. • Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces on the appliance.

  • Page 6: Lighting Instructions

    LIGHTING INSTRUCTIONS LIGHTING INSTRUCTIONS ARE ALSO LOCATED UNDER SIDE BURNER LID. OPEN LID. ENSURING BURNER CONTROLS ARE IN THE OFF POSITION, TURN ON THE GAS SUPPLY VALVE. LEFT REAR CENTER RIGHT SIDE INFRARED BURNER BURNER BURNER BURNER BURNER BURNER REAR BURNER LIGHTING SIDE BURNER LIGHTING MAIN BURNER LIGHTING (ROTISSERIE BURNER)

  • Page 7: Operating The Grill

    Cooking meat with a high degree of fat content, may create flare-ups. Either trim some fat or reduce temperatures to prevent this. Should a flare-up occur, move food away from flames, reduce heat. Leave the lid open. See 'Your All Season Grill' cookbook by Napoleon for more detailed instructions. INFRARED MAIN BURNER USE: 1.

  • Page 8: Infrared Heat

    Any juices or oils that escape from the food drip down onto the charcoal and vaporize into smoke giving the food its delicious grilled taste. The Napoleon infrared burner cooks in the same way. In each burner, 10000 ports each with its own tiny flame cause the surface of the ceramic to glow red.

  • Page 9: Maintenance/Cleaning Instructions

    This tray should be replaced every two to four weeks, depending on gas grill usage. For supplies, see your Napoleon Gas Grill dealer.
  • Page 10 CAUTION BEWARE OF SPIDERS WARNING It is very important when re-installing the burner after cleaning that the valve/orifice enters the burner tube before lighting your gas grill. If the valve is not inside the burner tube a fire or explosion could occur. INFRA RED BURNER - Because of the high intensity of the infrared burner, most drippings and food particles that fall onto the burner surface are immediately incinerated.

  • Page 11: Troubleshooting

    Allow burner to cool and inspect very closely for cracks. If Cracked ceramic tile. any cracks are found, contact your authorized Napoleon dealer for ordering a replacement burner assembly. Leaking gasket surrounding the Contact your authorized Napoleon dealer for instructions ceramic tile, or a weld failure in on ordering a replacement burner assembly.

  • Page 12: Ordering Replacement Parts

    ORDERING REPLACEMENT PARTS WARRANTY INFORMATION KEEP YOUR RECEIPT AS MODEL: PROOF OF PURCHASE TO VALIDATE YOUR DATE OF PURCHASE: WARRANTY SERIAL NUMBER: (record information here for easy reference) Before contacting the customer care department, check the NAC web site for more extensive cleaning, maintenance, troubleshooting and part replacement instructions at www.napoleongrills.com.

  • Page 13: Getting Started

    ASSEMBLY INSTRUCTIONS CAUTION: During unpacking and assembly it is recommended that you wear work gloves and safety glasses for your protection. Although we make every effort to make the assembly process as problem free and safe as possible, it is characteristic of fabricated steel parts that the edges and corners may be sharp and can cause cuts if handled incorrectly during assembly.
  • Page 14 2 x N430-0002 MAGNET CATCH Magnet Installation Snap magnets into slots in front of bottom shelf. 16 X 16 X N570-0073 (1/4-20 X 3/8”) N450-0027 (1/4-20) Caster Installation Attach (4) casters using (4) 1/4 - 20 X 3/8” screws and (4) 1/4-20 lock nuts for each caster.

  • Page 15: Left And Right Cart Panel Installation

    N570-0080 (#14 X 1/2") Left and Right Cart Panel Installation Install end cart panels ensuring slots in panel are to the top, rest panel on bottom shelf and line up holes. Fasten using (4) #14 x 1/2” screws.
  • Page 16 N570-0080 (#14 X 1/2") Rear Cart Panel Installation Fit rear cart panel between the two end panels, ensure large hole in panel is to the bottom right hand corner as illustrated. Fasten using (6) #14 x 1/2” screws, three on each side. Condiment Basket Rotate basket slightly to allow wire to enter the holes in the side panel.
  • Page 17 2 x N430-0002 N570-0080 (#14 X 1/2") MAGNET CATCH Front Cabinet Support Installation Fasten top rail assembly to the front of side panels using (4) #14 x 1/2” screws. For ease of installation, start all screws before tightening completely. Attach magnet brackets to bottom of top rail using (2) #14 x 1/2”...

  • Page 18: Grill Head Installation

    N570-0073 (1/4-20 x 3/8”) Grill Head Installation PROPANE ONLY - To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator up under control panel. This was installed at the factory to protect the regulator hose during shipping and is no longer re- quired.

  • Page 19: Side Shelf Installation

    10 x N570-0073 (1/4-20 x 3/8") Assembling End Caps to Side Shelf / Side Burner Peel protective coating from side shelf / side burner. Attach corresponding end cap as shown using (5) 1/4-20 x 3/8” screws. Bend tabs on front of shelf up with a flat head screw driver, insert screw...

  • Page 20: Side Burner Installation

    N735-0001 (1 1/16” insulated washer) N570-0082 (1/4-20 x 5/8") N160-0016 Side Burner Installation Insert (4)1/4-20 x 5/8” screws through washers into threaded holes in side of base. Do not tighten all the way. Slide assembled side burner over screw heads and finish tightening.
  • Page 21 N570-0080 (#14 X 1/2") Front Fascia Installation Attach front fascia to center of support beam. Slide top of fascia up under sup- port beam as shown, resting bottom on bottom shelf. Fasten with (4) #14 x 1/2” screws. PROPANE ONLY Tank Inhibitor Rod Installation Insert one end of tank inhibitor rod into hole in back panel and other end into hole in back side of fascia as illustrated.
  • Page 22 16 X N570-0080 (#14 X 1/2") Assembling Side Enclosures Take (1) side enclosure panel and place on solid surface. Fasten top and bottom to side using (8) #14 x 1/2” screws. Repeat for other side. 12 X N570-0080 (#14 X 1/2") Side Enclosure Installation Insert (2) #14 x 1/2”...
  • Page 23 8 x N120-0010 THREAD CAPS Thread Cap Installation Attach the supplied thread caps to the threads of the screws inside your grill cabinet as illustrated, both top and bottom. 4 x N430-0002 6 x N105-0011 DOOR BUSHING MAGNET CATCH Bushing and Magnet Installation Insert bushing into either end of bottom shelf and into either end of side enclo- sures both top and bottom.

  • Page 24: Cabinet Door Installation

    4 x N570-0073 4 X N735-0003 (1/4-20 X 3/8") (1/4” LOCK WASHER) Cabinet Door Installation Install door handle onto front of door using (2) 1/4-20 x 3/8” screws and (2) 1/4” washers per door. Insert pivot rod through hole on inside top of door. Holding door in one hand, direct pivot rod into hole in underside of front beam.
  • Page 25 4 x N570-0073 4 X N735-0003 (1/4-20 X 3/8") (1/4” LOCK WASHER) Side Enclosure Door Installation Install door handle onto front of door using (2) 1/4-20 x 3/8” screws and (2) 1/4” lock washers per door. Insert pivot rod through hole on inside top of door. Holding door in one hand, direct pivot rod into top bushing on the enclosure.
  • Page 26 3 X N305-0057 3 X N305-0060 1 X N520-0024 Sear Plate,Grill and Warming Rack Installation. Insert sear plates into base, positioning one over each tube burner with slots down to allow drippings to travel through. Rest warming rack on brackets inside hood, and insert grills into unit so they sit on back and front lip of base.

  • Page 27: Grease Tray And Holder Installation

    Grease Tray and Holder Installation Clip the wire grease tray holder into the two holes located in the center of the back panel. Place the aluminum grease tray into the grease tray holder. Drip Pan Installation Slide drip pan into rear of base as shown. Ensure drip pan rides along rails on bottom of base.
  • Page 28 PROPANE ONLY - PROPER HOSE CONNECTION Ensure the regulator drops into the small opening, between the tank heat shield and the right side of the cabinet. CLIP HOSE TO SIDE PANEL USING HOSE RETAINER CLIP SUPPLIED PROPANE ONLY - IMPROPER HOSE CONNECTION “WARNING - FIRE HAZARD”...

  • Page 29: Leak Testing Instructions

    LEAK TESTING INSTRUCTIONS DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury or death.

  • Page 30: Parts List

    PARTS LIST Item Part # Description N135-0024K left side lid casting N385-0129 NAPOLEON logo W450-0005 logo spring clips N570-0082 screw 1/4-20 x 5/8" N510-0010 black silicone lid bumper N685-0005 temperature gauge N185-0003 ice bucket N335-0044L stainless steel lid insert N585-0042...
  • Page 31 PARTS LIST Item Part # Description N725-0036 rear burner valve N475-0236P left / right side panel cabinet enclosure N555-0018 door pivot rod N010-0506 cart door assembly N325-0048 door handle N570-0073 door handle screw s N590-0150P bottom shelf N010-0515 front cabinet support N475-0189P rear cart panel N585-0041P...
  • Page 33 FAX TO: 705 727 4282 ACCESSORIES & PARTS ORDER FORM PLEASE PRINT CLEARLY CONTACT NAME:______________________________________________________________________ SHIP TO :_____________________________________________________________________________ _________________________________________________________________________________________ _________________________________________________________________________________________ _________________________________________________________________________________________ TEL :_________________________________ FAX :______________________________ EMAIL: __________________________________________________________________ VISA OR MASTERCARD # :_______________________________________ EXPIRY DATE: _____________ SIGNATURE:_____________________________________________________________________________ QUANTITY PART NUMBER DESCRIPTION TAXES MAY APPLY SHIPPING EXTRA IF CONFIRMATION IS REQUIRED PLEASE INCLUDE A FAX NUMBER OR EMAIL ADDRESS...

Table of Contents