Error Messages Related To The Vtr Module - Sony SRW-9000 Operation Manual
Hide thumbs
Also See for SRW-9000:
- Operation manual (221 pages) ,
- Brochure & specs (8 pages) ,
- Operation manual (207 pages)
Table of Contents
Advertisement
Error Messages Related to the
VTR Module
When the unit stops operating correctly because
of an internal error, a warning tone sounds and a
popup window appears on the display of the
control panel with an error message.
Only one message is displayed at one time, even
if multiple errors occur. But the number of current
errors appears at the bottom of the popup
window.
At the same time, a VTR module error message
appears in the viewfinder and in the message
display section of the monitor screen.
Example:
Popup window displaying error
message "007F HUMID ERROR"
(condensation detected)
There is one current error.
There are two current warnings (see page 186).
To view the other messages, turn the SELECT/
ENTER dial on the control panel.
When an error message appears
Check the message and eliminate the cause of the
error.
If the error involved the tape transport
mechanisms (SLACK-35, etc.), contact a Sony
service representative.
For other errors, power the unit off and on again.
If the same error message appears again when the
unit is powered on, contact a Sony service
representative.
To close the error message popup window
Press the HOME button or the BACK button on
the control panel.
If you press the HOME button, an error code
appears in the operation status and warnings
section of the control panel display (see page 25).
If you press the BACK button, the same error
code appears in the operation status and warnings
section of the display when you move back as far
as the HOME screen.
The error code remains visible until the cause of
the error is eliminated.
Tape protection mode
To protect the tape and the mechanical parts of
the SRW-9000, the servo control system
automatically stops tape transport and the drum
motor and enters tape protection mode when an
error occurs.
Cassettes may not be inserted or ejected while the
unit is in tape protection mode.
Error messages
Refer to the Maintenance Manual for more detailed
information about the content of error messages, and
about errors not listed here.
Code Message
0010 FAN STOP
0011
0012
0014 DC VOLTAGE
DOWN
0050 NO REC RF
0057 EQ NVRAM
SUM ERROR
0058 CONT REC NG
TC
005A CONT REC NG
SV
005C TIMER REC NG Timer Rec error was
005F EQ TEMP NG
0060 SLACK-10
0061 SLACK-11
0062 SLACK-12
Warning/Error Messages
Description
A cooling fan stopped.
Decline in power
supply voltage was
detected.
Recording error
occurred. Could not
detect RF signal.
EQ NVRAM operating
error was detected.
Continuous recording
error was detected.
Continuous recording
error was detected.
detected.
Abnormal EQ
temperature was
detected.
Drum drive voltage
error was detected.
Drum FG error was
detected.
Drum PG error was
detected.
185
Advertisement
Table of Contents
