Assistant Panel (Optional) - Sony SRW-9000 Operation Manual
Hide thumbs
Also See for SRW-9000:
- Operation manual (221 pages) ,
- Brochure & specs (8 pages) ,
- Operation manual (207 pages)
Table of Contents
Advertisement
voltage indication and the tally indicator flash,
and a warning tone sounds intermittently. When
the battery pack is completely exhausted, the tally
indicator flashes at a higher rate and the warning
tone sounds continuously.
For details, see "Warning System" (page 182).
The voltage actually used by the unit (slightly
lower than the input voltage to the DC IN 11-17V
connector) is shown.
For details on battery voltage and so on, see
"Checking the Power and Voltage" (page 28).
i Signal formats
When you press the HOME button with the
FUNC button held down, displays the system
(SYS), playback (PB), and monitor (MON)
output signal formats, in that order from the top
row.
When the unit is in one of the following modes,
an alphabetic character indicating the mode
appears before the number of lines.
T: Auto Timer Rec
M: Manual Timer Rec
C: Cache Rec
When SR Motion is used, "S" appears before the
system frequency. When you play a tape that was
recorded with SR Motion, the FPS value in SR
Motion recording is shown in the playback
frequency position (see page 98).
See Chapter 6 "SR Motion (With HKSR-9002
Installed)" (page 96) for more information about the
SR Motion function.
j HD SDI output
When the optional HKSR-9001 is installed,
displays the signal formats of monitor output
(MON) and the output of the HD SDI OUT A/B
connectors (OUT). The display switches when
you press the HOME button with the FUNC
button held down.
See "What Are Dual Link and 3G?" (page 193) for
more information about HD SDI output.
k SR Motion
When the SYSTEM >FORMAT >SELECT FPS
menu item is set to "ON" and the signal format is
being displayed, pressing both the FUNC and
HOME buttons together displays the FPS or FRM
on the second line and the memory level on the
third line.
26
Locations and Functions of Parts
See Chapter 6 "SR Motion (With HKSR-9002
Installed)" (page 96) for more information about the
SR Motion function.
AP-1 Assistant Panel (Optional)
By connecting the cable to the CTRL (CAM)
connector, you can operate the unit remotely. You
can also connect the AP-1 Assistant Panel to the
unit's left-side panel. The AP-1 provides the same
functions as the switches and buttons on the unit's
right-side panel.
See "Attaching the AP-1 Assistant Panel (Optional)"
(page 37) for more information about attaching the
AP-1.
1 Connection cable
2 LOCK switch (page 17)
3 VF MENU/DISPLAY button (page 18)
4 Assignable switches 1 to 3 (page 18)
5 CANCEL/STATUS button (page 18)
6 RUN button and indicator (page 17)
7 Assignable 4/AUTO BLK BAL switch
(page 17)
8 PAGE button (page 18)
9 SET button (page 18)
q; Subdisplay (page 18)
qa MENU SEL/ENTER dial (page 18)
Note
The cursor in the subdisplay may move
unexpectedly if you disconnect or connect the
assistant panel cable while operating the
subdisplay. If a ? symbol is shown on
the subdisplay, register the setting before
disconnecting or connecting the cable.
Advertisement
Table of Contents
