Table of Contents
Advertisement
ENGLISH
Support panels or any oversized workpiece to
e)
minimize the risk of wheel pinching and kickback.
Large workpieces tend to sag under their own weight.
Supports must be placed under the workpiece near the
line of cut and near the edge of the workpiece on both
sides of the wheel.
Use extra caution when making a "pocket cut" into
f)
existing walls or other blind areas.
The protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.
Labels on your tool
They may include the following symbols.
V
..........volts
A
..........Amperes
Hz
..........Hertz
W
..........Watts
..........Alternating current
n
..........No load speed
..........Class II Construction
..........Earthing terminal
..........Safety alert symbol
.../min ..........Revolutions or reciprocation per minute
:
Save these instructions!
Warning!To reduce the risk of injury, the user must
read the instruction manual.
Always wear safety glasses.
Wear ear protection.
Double Insulation
#
The tool is double insulated. Double insulation
means that all the external metal parts are
electrically insulated from the mains power supply.
This is done by placing insulated barriers between
the electrical and mechanical components so as to
making unnecessary for the tool to be earthed.
NOTE: Double insulation does not take the place of normal
safety precautions when operating this tool. The insulation
system is for added protection against injury resulting from a
possible electrical insulation failure within the tool.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the volt-
age on the rating plate.
6
@
Warning: Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an Extension Cable
An extension cable should not be used unless absolutely
necessary. Use of an improper extension cable could resultin
a risk of fire and electric shock. If an extension cable must
be used, use only those that are approved by the country's
Electrical Authority. Make sure that extension cord is in good
condition before using. Always use the cord that is suitable
for the power input of your tool (see technical data on name
plate). The minimum conductor size is 1.5mmWhen using a
cable reel, always unwind the cable completely.
Description (Fig. A)
Your Black and Decker small angle grinder has been
designed for grinding and cutting applications.
1. On/off switch
2. Side handle
3. Spindle lock
4. Wheel guard
5. Inner flange
6. Outer flange
Assembly and Adjustment
@
Prior to assembly and adjustment always unplug the
tool.
Mounting and Removing the Guard (Fig. B)
Mounting
Place the angle grinder on a flat and steady surface,
spindle (7) up (fig. B1)
Align the 3 lugs (8) with the 3 slots (9) in gearcase cover.
Press the guard (4) down and turn it in the direction of the
arrow until it is in the working position providing maximum
protection to the user (fig. B2)
Insert the bolt (11) to the holes on the bracket. Screw
the nut (12) on the thread of the bolt. Use crosshead
@
screwdriver (13) (not supply) to tighten the bolt and nut.
Do not operate the grinder with a loose guard.
Removing
Follow the procedure above in reverse order.
Mounting and Removing Grinding Wheels or
Cutting Discs (Fig. C & D)
.
Advertisement
Table of Contents
