Table of Contents
Advertisement
3. Determine the slot into which you want to install the hard disk drive.
4. Remove the filler panel:
5. Install the hard disk drive.
6. Check the drive LEDs.
7. Configure the hard disk drive using the applicable software.
8
System Storage EXP3000: Installation and User's Guide
a. Insert a finger into the square hole on the left side of the filler panel to grip
and pull the filler panel out of the drive bay.
b. Save the filler panel for future use.
Note: A hard disk drive comes with a tray already attached. Do not attempt to
detach the drive from the tray.
ra g
e
S to
m
st e
S y
a. Press the latch on the right end of the tray handle to release it.
b. Pull out the tray handle to the open position.
c. Gently slide the drive into the empty slot until the tray handle touches the
EXP3000 bezel.
d. Push the tray handle into the closed (latched) position.
a. When a drive is ready for use, the green activity LED and the amber status
LED are off.
b. If the amber status LED is lit and not flashing, remove the drive from the
unit and wait 10 seconds; then, reinstall the drive. If the amber LED is
flashing, the drive is rebuilding.
Controller management information: In some cases, the RAID controller will automatically
reset the drive to the Hot Spare or Rebuild state. If the drive state change does not occur
automatically (amber LED stays lit), refer to your controller management documentation for
information about manually changing the state of the drive from the current state to another
state, such as Hot Spare or Ready. The amber LED should turn off within 10 seconds after
the drive-state change.
Hard disk drive
Tray handle
Drive tray
Latch
Hide quick links:
Advertisement
Table of Contents
