Table of Contents
Advertisement
1. Read the safety information on page iii and "Installation guidelines" on page
21.
2. Turn off the power to the EXP3000. For more information, see "Turning off the
EXP3000" on page 18.
3. Disconnect the SAS cable from the ESM.
4. On the left side of the ESM, press the orange release tab to the right just
enough to release the handle [no more than 6.4 mm (0.25 in.)] as you rotate
the handle upward.
ESM
Release tab
5. Using the handle, gently slide the ESM out of the EXP3000.
6. Hold the new ESM so that the handle is fully extended.
7. Gently slide the ESM into the bay until it stops. Rotate the handle downward
into the closed position until it clicks.
8. Connect the SAS cable to the ESM.
9. Turn on the power to the EXP3000. For more information, see "Turning on the
EXP3000" on page 17.
10. Go to http://www.ibm.com/servers/storage/support/ to check for ESM code
updates. For more information, see the download instructions on page 1.
Handle
Chapter 4. Replacing components
25
Hide quick links:
Advertisement
Table of Contents
