Ipv6 Control-Plane Egress-Filter - Dell Z9500 Command Reference Manual

Table of Contents

ipv6 control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.

ipv6 control-plane egress-filter

Not enabled.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

permit (for IPv6 ACLs)

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or

permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count

[byte]] [dscp value] [order] [fragments] [log [interval

minutes] [threshold-in-msgs [count]] [monitor]

To remove this filter, you have two choices:

threshold-in

Introduced on the Z9500.

Introduced on the Z9000.

Introduced on the S4820T.

Introduced on the S4810.

Use the no seq sequence-number command syntax if you know the filter's

sequence number

Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp |

udp} command

(OPTIONAL) Enter the keyword log to enable the triggering

of ACL log messages.

(OPTIONAL) Enter the threshold-in-msgs keyword

followed by a value to indicate the maximum number of ACL

logs that can be generated, exceeding which the generation

IPv6 Access Control Lists (IPv6 ACLs)