Port-Channel Mode - Dell Z9500 Command Reference Manual

Table of Contents

port-channel mode

Configure the LACP port channel mode.

port-channel number mode [active] [passive] [off]

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Link Aggregation Control Protocol (LACP)

Enter the keywords number then a number.

Enter the keyword active to set the mode to the active

NOTE: LACP modes are defined in Usage Information.

Enter the keyword passive to set the mode to the passive

NOTE: LACP modes are defined in Usage Information.

Enter the keyword off to set the mode to the off state.

NOTE: LACP modes are defined in Usage Information.

Introduced on the Z9500.

Introduced on the Z9000.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

An interface is in an active negotiating state in this mode.

LACP runs on any link configured in the active state and also