Mac-Address-Table Static (For Multicast Mac Address) - Dell Z9500 Command Reference Manual

Table of Contents

information inside the ARP packet. This unicast data traffic flooding occurs only for

those packets which use these ARP entries.

mac-address-table static (for Multicast MAC Address)

To configure the multicast mode of network load balancing (NLB) on the switch, you must associate a

multicast MAC address with the VLAN used to switch Layer 2 multicast traffic, and add output ports that

will receive multicast streams on the VLAN in the MAC address table.

mac-address-table static multicast-mac-address vlan vlan-id

output-range {single-interface | interface-list | interface-

To remove a MAC address, use the no mac-address-table static

multicast-mac-address vlan vlan-id output-range interface

multicast-mac-

vlan vlan-id

output-range

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Microsoft Network Load Balancing

Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn

Enter a VLAN ID used to forward L2 multicast MAC traffic to

a server cluster. Valid VLAN IDs are from 1 to 4094.

NOTE: Use this option if you want multicast functionality

in an L2 VLAN without IGMP protocols.

For a multicast MAC address, enter the keyword output-

range then one of the following interfaces for which traffic

is forwarded:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.