Ip Pim Join-Filter - Dell Z9500 Command Reference Manual

Table of Contents

The following is a list of the Dell Networking OS version history for this command.

The router with the largest value assigned to an interface becomes the designated

router. If two interfaces contain the same designated router priority value, the

interface with the largest interface IP address becomes the designated router.

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command

prevents the PIM-SM router from creating state based on multicast source and/or group.

ip pim [vrf vrf-name] join-filter ext-access-list

To remove the access list, use the no ip pim [vrf vrf-name] join-filter

ext-access-list command.

vrf vrf-name

ext-access-list

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

PIM-Sparse Mode (PIM-SM)

Introduced on the S6000-ON.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the C-Series on port-channels and the S-

(OPTIONAL) Enter the keyword vrf followed by the name of

the VRF to permit or deny PIM join or prune messages on an

interface associated with that VRF.

Enter the name of an extended access list.