Ipv6 Pim Rp-Candidate - Dell Z9500 Command Reference Manual

Table of Contents

The RP addresses are stored in the order in which they are entered. RP addresses

learned via BSR take priority over static RP addresses.

Without the override option, the BSR-advertised RPs updates take precedence over

the statically configured RPs.

ipv6 pim rp-candidate

Specify an interface as an RP candidate.

ipv6 pim rp-candidate interface [priority-value]

priority-value

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

PIM-Sparse Mode (PIM-SM)

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter a number as the priority of this RP

Candidate, which is included in the Candidate-RP-

Advertisements. The range is 0 (highest) to 255 (lowest).

Introduced on the S6000-ON.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the S6000.