Match Ip Dscp - Dell Z9500 Command Reference Manual

Table of Contents

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.

match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]

To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |

ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.

CLASS-MAP CONFIGURATION (config-class-map)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

— identifies the class map.

Enter the keyword ip to support IPv4 traffic.

Enter the keyword ipv6 to support IPv6 traffic.

Enter the keyword ip-any to support IPv4 and IPv6 traffic.

Enter the IP DSCP values that is to be the match criteria.

Separate values by commas — no spaces ( 1,2,3 ) or indicate

a list of values separated by a hyphen (1-3). The range is from

(OPTIONAL) Enter the keywords set-ip-dscp then the IP

DSCP value. The matched traffic is marked with the DSCP

value. The range is from 0 to 63.

Added the ipv6 and ip-any options on the Z9500.

Added the ipv6 and ip-any options on the Z9000, S6000,

S4820T, S4810, MXL.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Quality of Service (QoS)