Dell Z9500 Command Reference Manual page 1509

Table of Contents

There are eight queues per interface on the Z9500. This command assigns a class

map or QoS policy to different queues.

service-policy input

service-policy output

Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.

set {ip-dscp value | mac-dot1p value}

ip-dscp value

CONFIGURATION (conf-qos-policy-in)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Quality of Service (QoS)

— identifies the class map.

— applies an input policy map to the selected interface.

— applies an output policy map to the selected interface.

(OPTIONAL) Enter the keywords ip-dscp then the IP DSCP

value. The range is from 0 to 63.

Enter the keywords mac-dot1p then the dot1p value. The

range is from 0 to 7.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added mac-dot1p on the C-Series and S-Series.

Introduced on the S-Series.

Introduced on the C-Series.

E-Series Only: Added support for mac-dot1p.

Introduced on the E-Series.