Ip Rip Send Version - Dell Z9500 Command Reference Manual

Table of Contents

pre- 6.2.1.1

If you want the interface to receive both versions of RIP, use the ip rip receive

version 1 2 command.

ip rip send version

ip rip send version

To send a specific version of RIP, set the interface. The version you set on the interface overrides the

version command in ROUTER RIP mode.

ip rip send version [1] [2]

To return to the default value, use the no ip rip send version command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Routing Information Protocol (RIP)

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— sets the RIP version for sending RIP traffic on an interface.

— sets the RIP version the switch software uses.

(OPTIONAL) Enter the number 1 for RIP version 1. The

default is RIPv1.

(OPTIONAL) Enter the number 2 for RIP version 2.

Introduced on the Z9500.

Introduced on the S4820T.