Protocol Spanning-Tree - Dell Z9500 Command Reference Manual
Hide thumbs
Also See for Z9500:
- Reference manual (1849 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Command
SPANNING TREE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.5.1.0
6.2.1.1
Related
forward-delay
Commands
state.
hello-time
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Z9500
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id
Defaults
Not configured.
Command
CONFIGURATION
Modes
Spanning Tree Protocol (STP)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the wait time before STP transitions to the Forwarding
— changes the time interval between BPDUs.
Enter zero (0). the system supports one spanning tree group,
group 0.
1775
Advertisement
Table of Contents
