Delay-Restore Abort-Threshold - Dell Z9500 Command Reference Manual
Hide thumbs
Also See for Z9500:
- Reference manual (1849 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Defaults
Not configured.
Command
VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
Usage
To delay the system from bringing up the VLT port for a brief period to allow IGMP
Information
Snooping and Layer 3 routing protocols to converge, use the delay-restore
parameter. Use this feature:
•
•
Related
show vlt statistics
Commands
delay-restore abort-threshold
Increase the Boot Up timer to some value (>60 seconds).
Syntax
delay-restore abort-threshold <interval>
To remove use the no delay-restore abort-threshold command.
Defaults
60 seconds
Command
VLT DOMAIN
Modes
Virtual Link Trunking (VLT)
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S8420T.
Introduced on the S4810.
after a VLT device is reloaded.
if the Peer VLT device was up at the time the VLTi link failed to the time when it
was restored.
— displays statistics on VLT operations.
1853
Advertisement
Table of Contents
