Table of Contents
Advertisement
Chapter 19
| Quality of Service Commands
set ip dscp
◆
The set cos and
set phb
Therefore setting either of these commands will overwrite any action already
configured by the other command.
Example
This example creates a policy called "rd-policy, " uses the
the previously defined "rd-class, " uses the set cos command to classify the service
that incoming packets will receive, and then uses the
the average bandwidth to 100,000 Kbps, the burst rate to 4000 bytes, and configure
the response to drop any violating packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set cos 3
Console(config-pmap-c)#police flow 100000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command modifies the IP DSCP value in a matching packet (as specified by the
match
command). Use the no form to remove this traffic classification.
Syntax
[no] set ip dscp new-dscp
new-dscp - New Differentiated Service Code Point (DSCP) value.
(Range: 0-63)
Default Setting
None
Command Mode
Policy Map Class Configuration
Command Usage
The set ip dscp command is used to set the priority values in the packet's ToS field
for matching packets.
command function at the same level of priority.
– 454 –
class
command to specify
police flow
command to limit
Hide quick links:
Advertisement
Chapters
Table of Contents
