Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 48

Table of Contents

Important information

Before starting up

During installation and before operating the device, observe the instructions

on environmental conditions for your device.

If the device is brought in from a cold environment, condensation may form

both inside and on the outside of the device.

Wait until the device has acclimatized to room temperature and is absolutely

dry before starting it up. Material damage may be caused to the device if this

requirement is not observed.

Transport the device only in the original packaging or in packaging that

protects it from knocks and jolts.

For the Japanese market, transporting the device in its original packaging

does not apply.

Installation and operation

This unit should not be operated in ambient temperatures above 35 °C.

If the unit is integrated into an installation that draws power from an industrial

power supply network with an IEC309 connector, the power supply's fuse

protection must comply with the requirements for non-industrial power

supply networks for type A connectors.

The unit automatically adjusts itself to a mains voltage in a range of 100 VAC

to 240 VAC. Ensure that the local mains voltage lies within these limits.

This device must only be connected to properly grounded power outlets or

connected to the grounded rack internal power distribution system with

tested and approved power cords.

Ensure that the device is connected to a properly grounded power outlet

close to the device.

Ensure that the power sockets on the device and the properly grounded

power outlets are easily accessible.

The On/Off button or the main power switch (if present) does not isolate the

device from the mains power supply. In case of repair or servicing

disconnect the device completely from the mains power supply, unplug all

power plugs from the properly grounded power outlets.

Upgrade and Maintenance Manual

TX300 S7 / RX350 S7

Primergy tx350 s7