Removing The Sas Raid Controller; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual
Hide thumbs
Also See for PRIMERGY TX300 S7:
- Upgrade and maintenance manual (962 pages) ,
- Operating manual (90 pages) ,
- System configurator and order-information manual (36 pages)
Table of Contents
Advertisement
9.5.2
Removing the SAS RAID controller
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
9.5.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Removing expansion cards:
●
– Phillips PH2 / (+) No. 2 screw driver
9.5.2.2
Preliminary steps
Before removing an the SAS RAID controller, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê Remove all external cables from the expansion card to be removed.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
Ê Remove the air duct as described in section
on page
92.
TX300 S7 / RX350 S7
133.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
Expansion cards and backup units
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
72.
(tower
481
Advertisement
Table of Contents
